Anything worth doing, is worth overdoing. I have a roofing/trim project coming up and need some sawhorses. They would make nice sofa tables for a faux industrial interior, even better when they have a few dings and paint spatters.
My own dear son asked why I’d spend so much time on sawhorses?
The through tenon and lap joints are a challenge. The wedge shape is cut with handsaws, a crosscut backsaw and my dovetail saw which is set to rip with the grain.
Legs splayed at 10° in two directions. You could park are car on these!
The dog holes are 3/4″, drilled on the drill press and routed with a chamfer bit. I’m not a total Luddite, hand tool purist.
Examples of quarter sawn 2×4 lumber. Note the difference in annual rings. The bottom board grew 3 or 4 times faster, but there doesn’t seem to be a big difference in strength. I shop often and keep the boards around for a few weeks to acclimate.
Maybe someone knows, what are the odds of getting cypress at the home center? The center board (with dog holes) and the legs are made from two fairly pristine 2×6’s. If it’s not cypress, it sure is similar. Slightly oily and tight grained.